Once I finished the open barrel I opened the basic barrel mesh again, this time deleting everything but the top. Extruding this down I had the basic mesh for the lid.
Wednesday, 13 February 2013
Open Barrel and Lid
After completing the barrel I decided to add some variations with an empty barrel and its lid. Starting with the original barrel mesh I extruded the top down into the bottom, then adjusted the UVs accordingly.
Once I finished the open barrel I opened the basic barrel mesh again, this time deleting everything but the top. Extruding this down I had the basic mesh for the lid.
Next came the UV mapping, using planar mapping on the top and bottom, and cylindrical on the sides.
Once I finished the open barrel I opened the basic barrel mesh again, this time deleting everything but the top. Extruding this down I had the basic mesh for the lid.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment